The newly developped INNOTECH-Drying center offers you the opportunity to reduce the actual high energy cost of the drying process significantly - at high product quality. The overflow air flow mode as well as the presetable recirculating mode

not only leads to a reduction of the specific energy requirement, but also guarantee uniform drying in the entire drying chamber - even without turning of the product and therefore without crumble losses and high labour requirement.

Special feature of the INNOTECH Drying center is the continuous recirculation of the drying air, which is mixed with a presetable, well defined amount of fresh air. Heat is transferred to the reciruclating air by means of an air-water heat exchanger which is installed in the upper level of the drying chamber. Heating can be done by gas, fossil fuel, wood, solar energy or even the waste heat of a districit heating central plant. Two high performance fans which produce an air flow rate up to 20 000 m³/h are installed for circulation of the air. After mixing with fresh air the

drying air is feeded vertically into the drying chamber. Up to 10 trolleys with 30 trays each can be loaded into the drying chamber. The trolleys are arranged wedge shaped in two rows. This arrangement leads to an uniform air distribution in the entire inlet cross section. Air flow happens over and above and not through the product. Due to that mode of air flow the air resistance and thus the energy requirement of the fan is significantly reduced. Furthermore a gentle and smooth drying occurs.

Both loading and unloading of the trolleys proceeds from the processing area by means of a separate sliding door. This arrangement enables a quasi-continuous operation of the unit.

High efficiency of all used components is a prerequisite for the desired low specific energy requirement. Therefore we use only well selected components of the leading European manufactures, which gives also the guarantee for robustness, reliability and high performance - necessary for  professional use.

Installation is done using preassembled parts within a few days. If desired installation can at least partly be made by yourself.